F Roof Decking | Keystar Industries

Same-Day Shipping & Cut-To-Order
Call or email for pricing and availability. (651) 256-0008


    Keystar Industries F Roof Deck products provide a convenient choice for any patching or repair project on flat roofs. F Decking at 1.5” deep, also known as intermediate rib roof deck, gives a wide support surface. This feature is ideal for applications where insulation requirements are lower.

    Features of F Decking

    The design and fabrication of F roof decking maximizes steel’s properties in order to create a high strength-to-weight ratio.  Lower material, handling, and erection costs result from using F roof decking.

    Keystar F decking products meet the required steel deck certifications in accordance with the specifications of the Steel Deck Institute. The material thickness of the intermediate rib deck stocked by Keystar measures 20 gauge. This structural metal decking measures 36” wide and can transfer horizontal and vertical loads into the building frame.

    This roof deck comes with a primed or galvanized finish. The most economical finish for type F decking is prime painted gray over bare steel. Typically, this finish provides adequate temporary protection to the base metal of the metal decking during construction.

    Comparison of F Roof Decking Types

    At present, F deck is rarely used for new construction projects but is often needed for repair and re-roof projects. Compared to Type B deck, Type F roof decking has a lower strength-to-weight ratio. Since F decking cannot carry as much load at longer spans as B deck, the steel supports below the metal deck must be spaced closer together. Smaller support spacing results in more supports and higher construction costs.

    When type A roof deck and type F roof deck were developed, the engineering community focused on the strength of the metal deck. However, it was only a secondary factor of concern. The primary objective was to maximize the width of the top flange. This factor provided the maximum amount of support for the roofing insulation that would be installed on top. Over time, roofing materials improved and steel deck manufacturers were able to reduce the width of the top flange. This reduction increased the efficiency from Type A deck to Type F Deck, and finally from Type F deck to Type B deck.

    F Roof Decking Supplier: Keystar Industries

    F Roof Decking comes in stock lengths of 25′-2″ and 20’–2”, or Keystar will cut to custom lengths, with a galvanized or primer painted finish.  Contact Keystar to buy F Roof decking for your roofing solutions. Call or email for pricing and availability. 651.256.0008 [email protected]